brand

KUERL

condition

New

Description

Kuer new model car audio subwoofer heavy bass big power 12V active car subwoofer 10 inch with tweeter

Model	K-1021PR
Subwoofer box shape	Trapezoid
Speaker Component	10 inch
RMS Power	120W
Max.Power	1200W
Impedance	4Ω
Frequency Response	20HZ-20KHZ
Sensitivity	89db
Weight	10.5KG

Kuerl K-1021APR Powered Subwoofer Sub Chamber Speaker 10 Inch 1200W

About the Kuerl K-1021APR

High Power Handling

This Kuerl K-1021APR subwoofer active motor vehicle subwoofer enclosure has a Polypropylene diaphragm for precise control and for stable and linear excursion. It has a high heat resistance voice coil due to its large magnet with high heat dissipation.

Quality Power

A quality 1200 Watts motor vehicle subwoofer provides powerful bass, while a cabinet-reinforcing heat sink is responsible for top sound performance, free of distortion. Play music at high volume levels with confidence.

Space Saving

The compact design of Kuerl pre-loaded car subwoofer with an in-built amplifier allows it to be installed in many places – behind the seat or in the car trunk. This active subwoofer is small and compact in size yet big in sound and it’s performance punch is an attention-grabber.

Kuerl K-1021APR subwoofer

Power input

1200 watts max power output.
300 watts RMS power output.

Audio

4 ohms impedance.
30 Hz to 20 kHz frequency response.
87 dB (1W/1M) Sensitivity.
Low pass frequency filters.

Woofer

10 inch speakers diameter.
Cone Type.
Ferrite Magnet Composition.
Rubber Surround.

Enclosure

Heavy duty carpeted enclosure.
Side ported cabinet enclosure.
Covered Steel Mesh Grille.
Compact size & waterproof enclosure.

Sub Super Depression Speaker 10 Inch 1200W 20Hz-20KHz K-1021APR: A series of subwoofer to recreate the lowest sound frequencies for sweet, sticky negative substances; tailor-made, Independent operation that reproduces low-frequency sounds ( bass) helps bring stronger sounds to your cast.

Laying speaker wire

Before connecting, measure the required wire length from the receiver to the sub Speaker 10 Inch ;, and remember to take a duplicate. Because if you connect with line-level then you will need a standard audio signal wire with; RCA jack at each end. Connect the wire from the recever subwoofer to the line-level of the subwoofer;
In addition, if you prefer to use Speaker-level, you must use multiple speaker wires ;, especially when the sub is far from the speaker. Then you need to run the strings from the left / right channel of the receiver to the sub and from there to the speakers;.

Connection and tuning

After installation later, turn on the audio system and start to tumble; adjust to hear if the sound is okay, or is it reasonable to see if the speaker position is reasonable ;, the sound is evenly covered with room space.
However, if the manufacturer has instructions that suggest you should; Install first, follow it. Plug the power cord, make sure volume on receiver for small size; Then turn on the system and subwoofer.

Product Specifications:

Size: 47*40*32cm
Box size: 49*42*69cm
Weight: 8.74kg
Maximum power: 1200W
Frequency: 20Hz-20KHz
Voltage: 12V

Cart

+254723 422 797

Cart

Kuerl K-1021APR Powered Subwoofer Sub Chamber Speaker 10 Inch 1200W